The fluid bed dryer is used for removing the residual moisture contained in the plastic flakes after the dewatering system.
This fluid bed drying system is designed for keeping the plastic flakes inside the big stainless steel cyclones with blown hot air for the necessary time to allow the water evaporation in order to reach moisture acceptable by extruders.
Below are some data relating to the dimensions and power of the solution. The data is indicative and not binding.
Model | A | B | C | KW | |||
|---|---|---|---|---|---|---|---|
mm | inch | mm | inch | mm | inch | ||
ESL 1 | 2200 | 87 | 1200 | 47 | 5250 | 207 | 9 |
ESL 2 | 2200 | 87 | 2400 | 94 | 5250 | 207 | 18 |
Tecnofer reserves the right to modify technical data and characteristics without prior notice.
Reliabiliy, Efficiency with Low Power Consumption
